 |
 |
|
Theelen, M., Harel, S., Verschuren, M., Tomassini, M., Hovestad, A., Barreau, N., van Berkum, J., Vroon, Z. & Zeman, M. (2016) Influence of Mo/MoSe2 microstructure on the damp heat stability of the Cu(In,Ga)Se2 back contact molybdenum. Thin Solid Films, 612 381–392.
Added by: Richard Baschera (2016-09-28 08:41:39) Last edited by: Richard Baschera (2016-09-28 09:37:16) |
| Type de référence: Article DOI: 10.1016/j.tsf.2016.06.028 Numéro d'identification (ISBN etc.): 0040-6090 Clé BibTeX: Theelen2016 Voir tous les détails bibliographiques  |
Catégories: INTERNATIONAL, MIOPS, PCM Mots-clés: cigs, damp heat, Degradation, intercalation, Molybdenum, Molybdenum oxide, selenization, Sodium Créateurs: Barreau, van Berkum, Harel, Hovestad, Theelen, Tomassini, Verschuren, Vroon, Zeman Collection: Thin Solid Films |
Consultations : 1/655
Indice de consultation : 5% Indice de popularité : 1.25% |
| Liens URLs http://www.science ... /S0040609016302723 |
| Résumé |
|
The degradation behavior of Mo/MoSe2 layers have been investigated using damp heat exposure. The two studied molybdenum based films with different densities and microstructures were obtained by lifting off Cu(In,Ga)Se2 layers from a bilayer molybdenum stack on soda lime glass. Hereby, a glass/Mo/MoSe2 was obtained, which resembles the back contact as present in Cu(In,Ga)Se2 solar cells. The samples were degraded for 150 h under standard damp heat conditions and analyzed before, during and after degradation. It was observed that the degradation resulted in the formation of needles and molybdenum oxide layers near the glass/Mo and the Mo/Cu(In,Ga)Se2 interfaces. X-ray Photoelectron Spectroscopy measurements have shown that the sodium was also present at the surface of the degraded material and it is proposed that the degraded material consists mostly of MoO3 with intercalated Na+. This element has likely migrated from the soda lime glass. This intercalation process could have led to the formation of NaxMoO3 ‘molybdenum bronze’ following this redox reaction:xNa+ + MoO3 + xe? ? NaxMoO3 It is proposed that the formed oxide layer contains NaxMoO3 with different Na+ contents and different grades of conductivity. This intercalation process can also explain the high mobility of Na+ via the grain boundaries in molybdenum. It was also observed that the molybdenum film with a top layer deposited at a high pressure is more susceptible for damp heat degradation.
|