 |
 |
|
Reyes-Figueroa, P., Painchaud, T., Lepetit, T., Harel, S., Arzel, L., Yi, J., Barreau, N. & Velumani, S. (2015) Structural properties of In2Se3 precursor layers deposited by spray pyrolysis and physical vapor deposition for CuInSe2 thin-film solar cell applications. Thin Solid Films, 587 112–116.
Added by: Laurent Cournède (2016-03-10 18:36:41) |
| Type de référence: Article DOI: 10.1016/j.tsf.2015.01.035 Numéro d'identification (ISBN etc.): 0040-6090 Clé BibTeX: ReyesFigueroa2015 Voir tous les détails bibliographiques  |
Catégories: CESES Mots-clés: alpha-in2se3, Copper indium selenide, cu(in, ga)se-2, gamma-in2se3, Indium selenide, performance, Physical vapor deposition, Spray pyrolysis Créateurs: Arzel, Barreau, Harel, Lepetit, Painchaud, Reyes-Figueroa, Velumani, Yi Collection: Thin Solid Films |
Consultations : 1/582
Indice de consultation : 4% Indice de popularité : 1% |
| Résumé |
|
The structural properties of In2Se3 precursor thin films grown by chemical spray pyrolysis (CSP) and physical vapor deposition (PVD) methods were compared. This is to investigate the feasibility to substitute PVD process of CuInSe2 (CISe) films by CSP films as precursor layer, thus decreasing the production cost by increasing material-utilization efficiency. Both films of 1 mu m thickness were deposited at the same substrate temperature of 380 degrees C. X-ray diffraction and Raman spectra confirm the formation of gamma-In2Se3 crystalline phase for both films. The PVD and CSP films exhibited (110) and (006) preferred orientations, respectively. The PVD films showed a smaller full width at half maximum value (0.09 degrees) compared with CSP layers (0.1 degrees). Films with the same crystalline phase but with different orientations are normally used in the preparation of high quality CISe films by 3-stage process. Scanning electron microscope cross-section images showed an important difference in grain size with well-defined larger grains of size 1-2 mu m in the PVD films as compared to CSP layers (600 nm). Another important characteristic that differentiates the two precursor films is the oxygen contamination. X-ray photoelectron spectroscopy showed the presence of oxygen in CSP films. The oxygen atoms could be bonded to indium by replacing Se vacancies, which are formed during CSP deposition. Taking account of the obtained results, such CSP films can be used as precursor layer in a PVD process in order to produce CISe absorber films. (C) 2015 Elsevier B.V. All rights reserved.
Added by: Laurent Cournède |