 |
 |
|
Nouveau, C., Labidi, C., Collet, R., Benlatreche, Y. & Djouadi, M. .-A. (2009) Effect of surface finishing such as sand-blasting and CrAlN hard coatings on the cutting edge's peeling tools' wear resistance. Wear, 267 1062–1067.
Added by: Laurent Cournède (2016-03-10 21:41:24) |
| Type de référence: Article DOI: 10.1016/j.wear.2009.01.045 Numéro d'identification (ISBN etc.): 0043-1648 Clé BibTeX: Nouveau2009 Voir tous les détails bibliographiques  |
Catégories: PCM Mots-clés: cemented carbide tools, CrAlN, performance, Sand-blasting, Wear resistance, wood, Wood machining Créateurs: Benlatreche, Collet, Djouadi, Labidi, Nouveau Collection: Wear |
Consultations : 1/475
Indice de consultation : 3% Indice de popularité : 0.75% |
| Résumé |
|
The aim of this study is first to define the effect of a surface finishing such as sand-blasting on the geometry of a wood cutting tool and its wear resistance. In addition, the effectiveness of surface coatings like CrAlN deposited by physical vapor deposition (PVD) technique on conventional and sand-blasted cutting edges was studied. A reference tool and different sand-blasted ones were tested by micro-peeling of beech in a laboratory. Microscopic observations, cutting forces measurement and cutting wear tests were carried out to quantify the behaviour of these tools. The results obtained showed that the artificial wear by sandblasting leads to an increase in the wear resistance and coating effectiveness, and completely changes the type of damage done to the tools. The sand-blasting application combined or not with CrAlN coating showed an improvement in the wear resistance of the tools and a modification of the forces during the peeling process. The effectiveness of the CrAlN layers was improved thanks to the sand-blasting treatment and then the duplex ones performed better. (C) 2009 Elsevier B.V. All rights reserved.
Added by: Laurent Cournède |